1.62. Mechanical transmission

Position of the lever of gear shifting is traditional for five transfers of the forward course as it is represented in the drawing.

Provisions of the lever of gear shifting

Prevention

At inclusion of transfer of a backing, after a full stop of the car, detain the gear shifting lever at least on 3 with in neutral situation. After that move the lever to the provision of transfer of a backing.
When switching the lever from the provision of the 5th transfer to the provision of the 4th transfer, you watch to including by mistake the second transfer. Such sharp gear shifting can be the cause of excessive increase in frequency of rotation of a bent shaft of the engine (the shooter of a tachometer in a red zone) and can lead to damage of the engine.


Coupling use

Before inclusion of transfer it is necessary to squeeze out completely a coupling pedal, and then slowly to release it. Repeated pressing a pedal of coupling needs to be made only after its reset. You do not hold a leg on a coupling pedal during the movement of the car. It can result in wear of a clutch plate. Do not use coupling for deduction of the car on a bias. For this purpose it is necessary to use the parking brake. Do not allow the sharp and repeating coupling pedal otpuskaniye.

Methods of the correct driving

You do not slide under a bias on neutral transfer. It is very dangerous. Always you hold transfer included.

Be not accustomed driving at which it is necessary to brake sharply, and you do not hold the left leg on a brake pedal constantly during driving. It conducts to an overheat of brakes and loss of efficiency of their work. On long descents it is necessary to apply braking to prevention of an overheat of brakes the engine (including low gears).

At inclusion of a low gear, slightly brake the car. It will help to prevent excessive increase in frequency of rotation of a bent shaft of the engine that can lead to its damage.

At a strong side wind reduce the speed of the movement of the car. It will improve its controllability.

Before inclusion of transfer of a backing be convinced that the car is completely stopped. Otherwise you can damage the transmission. To transfer the lever to the provision of a backing, at first squeeze out a coupling pedal, transfer the lever to neutral situation, wait 3 with, and then transfer the lever to the provision of a backing.

Be especially careful at movement along the slippery road, during braking, acceleration and gear shifting. On the slippery road, sharp change of speed of the car can lead to loss of coupling of wheels of the car with the road and loss of management over the car.


Prevention

At loss of control over the car at high speeds the risk of a turning of the car considerably increases.
Control loss often happens when two or more wheels move down from a road track, and the driver tries to return the car back on the road.
In case your car moved down from a road track, avoid sharp turn of a steering wheel. Instead, reduce car speed before again driving on the road.


To take out a key from the ignition lock

PERFORMANCE ORDER
1. Turn the ignition key in the provision of "ASS" ("The additional equipment").
2. At the same time press and turn the ignition key counterclockwise from the provision of "ASS" ("The additional equipment") in the provision of "LOCK" ("Blocking").
3. The ignition key can be taken out from the lock only in the provision of "LOCK" ("Blocking").

The recommended speeds for gear shifting

For economic driving it is recommended to switch transfers at the speeds provided below.

Transfer
The recommended speed
with the 1st on the 2nd or with the 2nd on the 1st
20 km/h
with the 2nd on the 3rd or with the 3rd on the 2nd
40 km/h
with the 3rd on the 4th or with the 4th on the 3rd
55 km/h
with the 4th on the 5th or with the 5th on the 4th
75 km/h