db57d230

10.4. A power shaft with Birfield CV JOINTS and tripoidny type

1 – lock ring;
2 – CV JOINT of tripoidny type;
3 – lock spring ring;
4 – support of rollers of tripoidny connection;
5 – protective cover;
6 – collar;
7 – collar;
8 – nut, 220–260 N • m;
9 – dustproof ring;
10 – Birfield CV JOINT;
11 – protective cover;
12 – collar;
13 – collar;
14 – dynamic damper;
15 – clip of a dynamic damper.

Dismantling

Prevention

Do not disassemble the Birfield CV JOINT.
For lubricant of CV JOINTS use only special lubricant.
At assembly of the CV JOINT it is necessary to establish new collars.


PERFORMANCE ORDER
1. Remove collars and pull together a protective cover from the ball CV JOINT of a power shaft.

Prevention

Be careful not to damage a protective cover.


2. Special passatizha remove a lock ring and the hammer through a brass core bring down a support of rollers of tripoidny connection from a power shaft.

Prevention

At removal of a support of rollers of tripoidny connection from a power shaft do not establish a brass core on rollers.


3. Clear a support of rollers of tripoidny connection.
4. Remove collars and pull together protective covers of the ball CV JOINT and Birfield CV JOINT.

Prevention

If the protective cover is reused before removal of a cover for its protection, wrap up vents of a power shaft an adhesive tape.



Check


PERFORMANCE ORDER
1. Check a condition of shlits of a power shaft.
2. Check for lack of traces of a rust, water and foreign objects in a protective cover of the Birfield CV JOINT.
3. Check a support of rollers of tripoidny connection for lack of wear or corrosion.
4. Check deepening in the Birfield CV JOINT for lack of wear or corrosion.
5. Check a dynamic damper for absence of damage.

Assembly

PERFORMANCE ORDER
1. Before installation of a cover for its protection wrap up vents of a power shaft from the tripoidny hinge an adhesive tape.
2. Apply lubricant on a power shaft and establish a cover.

Birfield CV JOINT lubricant: Centoplex 278M/136K TJ
Lubricant of the tripoidny CV JOINT: KLKTJ41–182 (MS511-50, KOREYA KLUBER)

3. For installation of a dynamic damper arrange the Birfield CV JOINT on a straight line in relation to a shaft, arrange a damper at distance of 437±3 mm and fix it by a clip.
4. Enclose lubricant in a protective cover of the tripoidny CV JOINT and install a cover on the hinge.

Protective cover of the tripoidny hinge:
Total of lubricant: 95±6 g
Hinge: 60±3 g
Protective cover: 35±3 g

5. Add so much lubricant how many it was wiped during check of the hinge to the Birfield CV JOINT.
6. Establish covers.
7. Fix a protective cover of the Birfield CV JOINT by collars.
8. Fix covers so that length of a power shaft corresponded to the required values

Length of the left power shaft:
With the mechanical transmission: 645,2±2 mm
With the automatic transmission: 648,9±2 mm
Length of the Right power shaft:
With the mechanical transmission: 930,5±2 mm
With the automatic transmission: 934,2±2 mm.