db57d230

11:10. Angles of installation of forward wheels

An inspection of angles of installation of forward wheels needs to be carried out at the special stand, at the same time the car has to be in horizontal position with the forward wheels established for the rectilinear movement. Previously be convinced that the forward suspension bracket and steering are in the normal state, tires and wheels have no defects.

Convergence

The convergence is defined as a difference of distances (V-and) between forward and back boards of rims of wheels. The positive convergence means that wheels are in front located more closely to each other, than behind, at measurement at height of an average point of a wheel. If the convergence does not correspond to the required value, weaken the left and right lock-nuts of tips of steering drafts, then, rotating drafts, establish the required corners. Tighten lock-nuts. The turn on S turns of connecting drafts changes a positive convergence approximately to 5,5 mm.

Convergence: 0±3 mm

Prevention

Adjustment of a convergence has to be carried out by rotation of the left and right tip of steering draft on an identical corner.
At adjustment of a convergence weaken an external collar of fastening of a protective cover to prevent its twisting.
After adjustment tighten lock-nuts of tips of steering drafts and collars of fastening of covers.


Moment of an inhaling of lock-nuts: 50–55 N • m

Disorder

Disorder is a tilt angle of a wheel in relation to a paving in the vertical plane. It can be positive if wheels are inclined outside, or negative if wheels are inclined inside. The disorder corner, generally influences cross forces.

Disorder: 0 ° ± 30'

Corner of a longitudinal inclination шкворня

The corner of a longitudinal inclination шкворня is established at production of the car and cannot be regulated. If the corner of a longitudinal inclination шкворня does not correspond to the required values, replace the bent or damaged details.

Corner of a longitudinal inclination шкворня: 1 °48 '±30'

Prevention

Before check and adjustment of angles of installation of wheels the forward suspension bracket has to be free from the worn-out, free or damaged details.
Adjustment of angles of installation of wheels needs to be carried out, using the special tool 09529-21000.
Disorder and corner of a longitudinal inclination шкворня are established at production of the car and cannot be regulated.
If disorder and a corner of a longitudinal inclination шкворня do not correspond to the required values, replace the bent or damaged details.