11.9. Back stabilizer of cross stability

PERFORMANCE ORDER
1. Remove draft of the stabilizer of cross stability.
2. Check torque which needs to be put for a provorachivaniye of a pin of the spherical hinge of draft of the stabilizer.

If there are cracks in a protective cover, replace it and add lubricant to the hinge.

Several times shake here and there a pin of the spherical hinge of draft of the stabilizer.

Screw on a pin of the spherical hinge самоконтрящуюся a nut and measure torque.

Torque: 1,7–3,2 N • m

If the torque exceeds admissible values, replace draft of the stabilizer.

If the torque is much lower than admissible value, the spherical hinge can be reused if it is not got jammed and has no excessive side play.

3. Establish draft of the stabilizer and fix by a nut so that the lower nut settled down at distance And from a draft end face.

Distance (A) from an end face draft of the stabilizer to a nut: 4–6 mm