11. Suspension bracket

DEPRECIATION RACK OF THE FORWARD SUSPENSION BRACKET

1 – lower support of a spring;
2 - dustproof cover;
3 – top support of a spring;
4 – rack support;
5 – самоконтрящаяся nut, 60–70 N • m;
6 - dustproof cap;
7 – nut *, 20–30 N • m;
8 – spring;
9 – depreciation rack of a forward suspension bracket;
10 – nut, 75–90 N • m.

Prevention

* The nut which needs to be tightened the required moment only after installation of the car on wheels is noted.


Removal

PERFORMANCE ORDER
1. Remove a forward wheel.
2. Separate an arm of a brake tube of the brake system from a rack of a forward suspension bracket.

Prevention

Do not tear and do not damage a brake tube.


3. Turn off nuts of the top fastening of a rack.
4. Turn off nuts and get bolts of fastening of a rack to a rotary fist and get a rack from under a car wing.
5. Installation is carried out to the sequences, the return to removal.

Dismantling

PERFORMANCE ORDER
1. An edge of the flat screw-driver take off a dustproof cap.
2. Special adaptation squeeze a spring of a rack of a forward suspension bracket.

Prevention

For compression of a spring use only the reliable tool.


3. Turn off a lock nut in the top part of a rod of the shock-absorber.
4. Remove a rack support, the top support of a spring, a cylindrical spring, a dustproof cover and the lower support of a spring.

Check

PERFORMANCE ORDER
1. Check the rack support bearing for lack of wear or damages.
2. Check rubber details for absence of damage or deteriorations in their state.
3. Check a cylindrical spring for lack of a deflection and loss of elasticity.
4. Check the shock-absorber as follows:

a. undertake a hand a rod of the shock-absorber and several times press and extend it from the shock-absorber;
b. check that the rod moves smoothly, without jammings, and the effort enclosed to a rod does not change with each course;
c. be convinced that when moving a rod there are no extraneous noises.

Assembly

PERFORMANCE ORDER
1. Establish the lower support of a spring so that its ledges entered plate openings of a spring.
2. Install a dustproof cover on the shock-absorber.
3. Special adaptation squeeze a spring of a rack of a forward suspension bracket. After full compression of a spring install it on the shock-absorber.

Prevention

Establish a cylindrical spring by the marking directed to the hinge.


4. Completely extend a rod of the shock-absorber and establish the top support of a spring and a support of a rack.

Prevention

Combine a D-shaped opening in the top support of a spring with lysky on a shock-absorber rod.


5. Correctly arrange the top and lower ends of a cylindrical spring, having established them in dredging, and screw самоконтрящуюся a nut, but do not tighten it finally.
6. Remove the device for compression of a spring.
7. Tighten самоконтрящуюся a nut the required inhaling moment.

Inhaling moment: 60–70 N • m

8. Grease the top bearing of a depreciation rack and establish a dustproof cap.

Prevention

Make sure that lubricant did not get on rubber details of a support of a rack.