12:12. Pumping of hydraulic system of the amplifier of steering

PERFORMANCE ORDER
1. Disconnect a high-voltage wire from the ignition coil. Periodically include a starter on 15-20 with and at the same time 5–6 times turn a steering wheel from an emphasis against the stop.

Prevention

In the course of pumping constantly add liquid that its level in a tank did not fall below a filter installation site.
If to execute pumping when the bent shaft of the engine does not rotate, air will be dissolved in liquid again. Make sure that carried out pumping at the time of a provorachivaniye of a bent shaft of the engine.


2. Connect a high-voltage wire to the ignition coil, launch the engine and leave it to work at idling rotation frequency.
3. Turn a steering wheel from an emphasis against the stop several times. Check that liquid does not foam and its level did not go down.

Prevention

To exclude damages, do not hold the steering wheel turned against the stop within more than 10 seconds.


4. Check that liquid has no dairy color and its level is between tags on the probe.
5. Check that there is a little change of level of liquid at turn of a steering wheel in the left and right parties.

Prevention

If the level of liquid changes considerably, repeat pumping of hydraulic system of the amplifier of steering.
If the level of liquid increases suddenly after an engine stop, so in system still there is an air.
If in the hydraulic drive of the amplifier of steering there is an air, during the operation of the pump extraneous noise will be heard. Air in system will reduce a resource of operation of the pump and other parts.