db57d230

14:16. Windshield

1 – expansion plug of a windshield;
2 – windshield molding;
3 – internal rear-view mirror;
4 – windshield;
5 – windshield lining.

Removal

PERFORMANCE ORDER
1. Before removal of a windshield remove the following elements:

- top upholstery of a forward rack;
- internal rear-view mirror;
- screen wiper levers;
- overlay of the top part of a cowl;
- windshield molding.
2. The special tool 09861-31100 cut sealant of fastening of a windshield.
3. If glass is repeatedly established, leave a sealant layer on glass and a body. Note the provision of glass on a car body.
4. The special tool 09861-31400 remove a windshield from the car.

Installation

PERFORMANCE ORDER
1. The special tool or a knife cut off old sealant to thickness of a layer of 2 mm on all perimeter of a frame and windshield.

Prevention

Be careful not to remove sealant more, than it is necessary, and also not to damage a paint and varnish covering of the car.


2. Degrease the processed surface.
3. Apply a windshield to a window opening and in four points on a body note glass installation sites.
4. Paste a rubber lining to an internal surface of a windshield.

Sealant layer height:
Above: 13,5 mm
From sides: 13,5 mm
From below: 27 mm

5. Establish a windshield.
6. Apply a thin film of glass primer on outer side of a rubber lining of a windshield.

Prevention

Do not touch a sealant layer by a hand.
In the place of a contact of sealant with a hand it cannot provide reliable connection and in this place leaks after glass installation are possible.
You do not apply the primer intended for a body on glass.


7. Apply a thin film of primer on originally applied sealant acting on glass perimeter. Glass needs to be established within 10 min. after putting primer.
8. Put glue in the syringe and put it on edge of a windshield.

Prevention

Apply glue within 5 min. after putting glass primer.


9. Establish by the special tool or suckers glass over a window opening according to earlier put tags and press glass to a window opening.
10. Remove with the pallet excess glue. Fill all sinks and emptiness on windshield perimeter.
11. Directing a water stream to a windshield, check tightness of its installation. Do not direct to fresh sealant a water stream under big pressure.
12. In the presence of leaks dry up the damaged area and apply sealant.

Prevention

Do not operate the car within 4 hours after glass installation.
After installation of a windshield support it within the first hour.


13. Establish into place all earlier removed elements.

Prevention

Within 2-3 days after installation of a windshield do not slam the doors.
Avoid movement along uneven roads where the body of the car is exposed to intensive twisting.