4.5. Tubes and hoses of the cooling system
Tubes and hoses of the cooling system of the SOHC engine
1 – bolt, 10–15 N • m;
2 – bypass hose;
3 – sealing ring;
4 – union of an exit of cooling liquid; | 5 – a hose for cooling liquid;
6 – a hose of supply of cooling liquid to a heater. |
Tubes and hoses of the cooling system of the DOHC engine
| 1 – entrance pipe of cooling liquid; | 2 – union of an exit of cooling liquid. |
Check
| PERFORMANCE ORDER |
| 1. Check tubes and hoses of the cooling system for absence of damage, cracks and swellings. | | 2. If necessary replace them. | |
Replacement
| PERFORMANCE ORDER |
| 1. At connection of a hose to the union of an exit of cooling liquid previously grease a sealing ring with cooling liquid. |
| 2. Make sure that the yellow tag on the end of an entrance hose of cooling liquid was combined with a yellow tag on the union. |
|
Prevention
Do not oil a sealing ring or lubricant.
Before installation of hoses clear unions of dirt, dust and sand.
Insert a pipe of cooling liquid against the stop into the water pump.
At installation use only a new sealing ring.
