db57d230

9.1.6. Removal and installation of the transmission

Mechanical transmission

1 – bolt, 27–34 N • m;
2 – speedometer cable;
3 – coupling case cover;
4 – bolt, 8–10 N • m;
5 – cable of the choice of transfers;
6 – gear shifting cable;
7 – starter.

Removal

PERFORMANCE ORDER
1. Disconnect, first of all, a wire from the negative plug of the rechargeable battery, then – from positive. Turn out a drain stopper and merge in suitable capacity gearbox oil from the transmission.
2. Remove the working cylinder of switching off of coupling.
3. Remove the case of the air filter.
4. Remove the rechargeable battery and a support of the battery.
5. Remove a cable of the choice and gear shifting.
6. Disconnect the backing light switch socket.
7. Remove a speedometer drive cable.
8. Disconnect a hydraulic tube of the drive of coupling and close the end of a pipe a suitable stopper.
9. Remove a casing from the engine and a casing sideways of the transmission.
10. Remove forward and back arms.
11. Remove the right forward wheel.
12. Turn out a bolt of fastening of the spherical hinge of a forward rack.
13. Insert mount between the internal CV JOINT of a power shaft and the transmission and easy blow to mount take a power shaft from the transmission.
14. Remove a starter.
15. Support by special adaptation 09400-29000 the engine so that the weight of the engine was perceived by adaptation.
16. Remove the left arm of the transmission.
17. Turn out the top bolts of fastening of the transmission.
18. Uncover a coupling case.
19. Support the transmission by a jack.
20. Turn out the lower bolts of fastening of the transmission.
21. Remove a casing of coupling and the conducted clutch plate.
22. Remove a flywheel.

Installation


PERFORMANCE ORDER
Installation of the transmission is carried out to the sequences of the return to removal.