db57d230

9.1.9. Hydraulic drive of coupling

1 – coupling drive hose;
2 – coupling drive tube;
3 - main cylinder of coupling;
4 – coupling pedal.

Removal

PERFORMANCE ORDER
1. Turn out the union of pumping and merge brake fluid from the hydraulic drive of coupling.
2. Remove the forelock, a washer and a pin with a head and an opening under the forelock.
3. Disconnect a hydraulic tube from the main cylinder of coupling.
4. Turn out a bolt of fastening of the main cylinder of coupling.
5. Remove clips of the hydraulic line of coupling.
6. Holding from a provorachivaniye a nut on a coupling drive hose, turn off a nut on a tube.
7. Remove a clip of fastening of a hose of the drive of coupling and remove a hose from an arm.
8. Remove the hydraulic line of the drive of coupling.
9. Disconnect a tube from a coupling hose.

Check

PERFORMANCE ORDER
Check a hose and a tube of the hydraulic drive of coupling for lack of cracks and damages.

Installation

PERFORMANCE ORDER
1. Connect a coupling tube from a coupling hose.
2. Temporarily, by hand, tighten nuts of fastening of a hose and a tube of a wire of coupling then tighten them the required inhaling moment.

Inhaling moment: 13–17 N • m

3. Establish the hydraulic line of the drive of coupling and fix by clips.
4. Install the main cylinder of coupling.
5. Before installation grease the plug, a pin, a washer and a pin with a head and an opening under the forelock.

Lubricant: J310a, NLGI No. 2

6. Establish a pusher on a coupling pedal.
7. Fill in liquid in a coupling tank.
8. Remove air from hydraulic system of the drive of coupling