db57d230

9.2.16. Selector lever

1 – cable of control of the transmission;
2 – nut;
3 – blocking lock solenoid;
4 – wire and lamp of illumination of the control panel of the transmission;
5 – O/D switch;
6 – button;
7 – handle;
8 – control panel of the transmission;
9 – adjusting cam of the lever;
10 – selector lever;
11 – switch of neutral position of the transmission;
12 – arm;
13 – connecting tip of a cable.

Removal

PERFORMANCE ORDER
1. Remove the central console.
2. Turn out screws of fastening of the handle of the lever of the selector.
3. Disconnect the socket of the switch of an overdrive gear, get three contacts from the socket and remove the handle from the lever.
4. Disconnect the socket of a lamp of illumination of the control panel of the transmission.
5. Remove the control panel of the transmission.
6. Remove a draft fastening clip.
7. Remove a clip from the selector lever.
8. Turn out bolts and remove washers of fastening of a cable under the dashboard.
9. Remove a clip of fastening of a cable from the transmission.
10. Remove a cable of control of the transmission.

Check

PERFORMANCE ORDER
1. Check functioning of a cable of control of the transmission and absence of damage.
2. Check the plug for lack of wear or damages.
3. Check a spring for absence of damage and loss of elasticity.
4. Check conductivity of the switch of an overdrive gear. At activation of an overdrive gear contacts 1 and 2 switches have to be closed, and at deactivation contacts 1 and 3 have to be closed.

Installation

PERFORMANCE ORDER
1. Grease an internal part of the plug.

Lubricant: SAE J310, NLGI No. 0

2. Move the lever of the selector and the switch of range of the transmission to a position N and connect a cable of management.
3. At connection of a cable of control of the transmission move a cable arm until the cable is combined with the transmission lever.
4. Establish a washer and screw a bolt and a nut of fastening of a cable.
5. From the lever of the selector establish a clip.
6. Connect the socket of a lamp of illumination of the indicator of position of the lever of the selector, the O/D switch socket, the socket of the switch of the parking and the socket of the choice of the mode of the movement.
7. Install the control panel of the transmission.
8. Apply lubricant in the place shown in the drawing.

Lubricant: SAE J310, NLGI No. 2

9. Install the selector lever in a position N, then turn an overlay of a cam so that the gap between an overlay of a cam and knot corresponded to the required value.

Gap: 15,2–15,9 mm


Prevention

Make sure that the party In adjusting a cam of the lever was located from the button.


10. Install the O/D switch on the lever handle, then insert contacts into the switch socket.
11. Install the handle of the lever and fix it by two screws.
12. Install the central console.